001 Leading edge of the recording paper fails to reach the Timing Sensor copyir.com (1st Cassette) Recording paper jam copyir.com Timing Sensor abnormal copyir.com
002 Leading edge of the recording paper fails to reach the Timing Sensor copyir.com (2nd Cassette) Recording paper jam copyir.com Timing Sensor abnormal copyir.com
007 1 copyir.com Leading edge of the recording paper fails to reach the Paper Exit Sensor copyir.com 2 copyir.com Recording paper has not completely passed the Paper Exit Sensor copyir.com Recording paper jam copyir.com Paper Exit Sensor abnormal copyir.com
010 No recording paper copyir.com No recording paper or paper is not set properly copyir.com No Paper Sensor is defective copyir.com
011 Paper Cassette is not installed properly copyir.com
012 The length of the received document is over 2 meter (78 copyir.com7in) copyir.com
021 Thermistor is abnormal copyir.com Fuser Control is abnormal copyir.com Fan is abnormal copyir.com Defective SC PCB copyir.com Defective Fuser Unit, Power Supply Unit copyir.com Defective Fan copyir.com
030 Read Point Sensor does not go ON within 10 seconds after the document starts feeding copyir.com Document is not set properly copyir.com Defective Read Point Sensor copyir.com
031 Transmitting document was longer than 2 meter (or 78 copyir.com7 in) copyir.com The document may jam copyir.com Defective Read Point Sensor copyir.com
041 Out of toner copyir.com No toner copyir.com Defective Toner Sensor copyir.com
043 Low toner copyir.com Toner is getting low copyir.com Defective Toner Sensor copyir.com
045 No Toner Cartridge copyir.com Toner cartridge has not been installed copyir.com Defective Toner Sensor (Cartridge Sensor) copyir.com
051 Printer Motor abnormal copyir.com Connector not properly connected copyir.com Defective Printer Motor copyir.com Defective SC PCB copyir.com
054 HSYNC abnormal copyir.com Motor abnormal copyir.com Defective Laser Unit copyir.com
060 Printer Cover is open copyir.com Cover is not firmly closed copyir.com Connectors are not firmly connected copyir.com
061 ADF Door is open copyir.com Door is not firmly closed copyir.com Connectors are not firmly connected copyir.com
200 Decoding process is not completed at the end of phase C copyir.com Defective SC PCB copyir.com
212 Interface error occurred between the CPU and modem copyir.com Modem is defective copyir.com (SC PCB) Software problem occurred copyir.com (SC PCB)
301 System fault copyir.com Software problem occurred copyir.com (SC PCB)
331 8-minutes timer error copyir.com (Germany only)
390 Interface error occurred between the machine and the PC copyir.com Firmware update error copyir.com GDI print error copyir.com (Perform the operation again)
400 T1 timer (35±5 sec copyir.com) elapsed without detecting 300 bps signal copyir.com Wrong number is dialed and the START button is pushed copyir.com Telephone line is disconnected while dialing copyir.com SC PCB (Modem) or MJR PCB are defective copyir.com Receiver is defective copyir.com (It may only be transmitting CED)
401 DCN was returned from receiver while transmitter is waiting for CFR or FTT copyir.com Your machine’s ID Number is not programmed copyir.com Possible incompatibility or incorrect Password copyir.com
402 DCN was returned from receiver while transmitter is waiting for NSF/DIS copyir.com Receiver working in non-CCITT mode only copyir.com (Possible incompatibility)
403 Transmitter had no polling function copyir.com “POLLED=ON” (polling XMT ready) is not set at the transmitter copyir.com Document to be transmitted is not placed at the transmitter copyir.com
404 Transmitter sent NSS (or DCS) followed by TCF three times, but the receiver did not respond copyir.com (CFR or FTT is usually returned) Receiver is defective copyir.com (Modem, MJR PCB, etc copyir.com) SC PCB or MJR PCB are defective copyir.com Receiver disconnects line during first NSS (or DCS) is transmitted copyir.com
405 Transmitter received FTT after it transmitted TCF at 2400bps copyir.com Received RTN after communicating at 2400 bps copyir.com Line quality is poor copyir.com (TCF is damaged due to line noise) Receiver is defective copyir.com (Modem, etc copyir.com) SC PCB or MJR PCB are defective copyir.com
406 XMT-Password mismatched copyir.com RCV-Password mismatched copyir.com Selective RCV incomplete copyir.com XMT, RCV password does not match copyir.com Last 4 digits of TSI does not match with the last 4 digits of ONE-TOUCH, ABBR telephone number copyir.com
407 Transmitter received no response after it transmitted post message, such as EOP, MPS, EOM, etc copyir.com copyir.com copyir.comor received DCN copyir.com Receiver is defective copyir.com (No paper, paper jamming, etc copyir.com) Receiver ceased receiving because of excessive error copyir.com (Line quality is poor) SC PCB (Modem) or MJR PCB are defective copyir.com
408 Transmitter received RTN after it transmitted EOP, MPS, or EOM copyir.com Receiver receives data with error copyir.com (Line quality is poor) Receiver is defective copyir.com (Modem, etc copyir.com) SC PCB or MJR PCB are defective copyir.com
409 Transmitter receives PIN after it transmitted a post message, such as EOP, MPS, EOM, etc copyir.com Receiver receives data with error due to poor line quality, and receiving operator requests voice contact copyir.com Receiver is defective copyir.com (Modem, etc copyir.com) SC PCB or MJR PCB are defective copyir.com
410 Received DCN while waiting for post command copyir.com (EOP, MPS, EOM, etc copyir.com) Interface or line is faulty copyir.com Transmitter is defective copyir.com
411 Received DCN after transmitting NSC copyir.com Transmitter is not ready for polling communication copyir.com Password does not match between transmitter and receiver copyir.com
412 No response within 12 seconds in NSS/DCS/MPS wait state copyir.com (After transmitting FTT) Transmitter is defective copyir.com SC PCB is defective copyir.com
414 No response received after transmitting 3rd NSC copyir.com Password does not match between transmitter and receiver copyir.com Transmitter is defective copyir.com (No original, document jam, etc copyir.com)
415 Remote side attempted to receive message from your machine in polling communication copyir.com Inform the remote side that your machine does not have the polling transmission feature copyir.com
416 Receiver did not detect post command, such as EOP, MPS, EOM, etc copyir.com Transmitter is defective copyir.com Line quality is poor copyir.com (RTC signal is distorted due to line noise) SC PCB or MJR PCB are defective copyir.com
417 Receiver returned RTN in response to post message copyir.com Line quality is poor copyir.com (There are excessive errors in received data) SC PCB or MJR PCB are defective copyir.com
418 Receiver transmitted PIN in response to PRI-Q from transmitter copyir.com (Transmitting operator requests voice contact) Line quality is poor copyir.com (There are excessive errors in received data) SC PCB or MJR PCB are defective copyir.com
420 T1 timer (35 sec copyir.com) elapsed without detecting 300 bps signal copyir.com There is wrong incoming call copyir.com(nonfacsimile communication) Transmitter is defective copyir.com SC PCB or MJR PCB are defective copyir.com
421 Busy Tone is detected after sending NSF Signal copyir.com Remote station disconnected the line copyir.com Wrong number is dialed copyir.com
422 Content of NSF (or DIS) or NSC (or DTC) was invalid copyir.com There is an incompatibility copyir.com
427 DCN received to NSF/CSI/DIS transmitted The interface is incompatible copyir.com
433 copyir.comT copyir.com30 Protocol abnormal copyir.com Defective remote station copyir.com
434 CD (response from Modem) did not turn OFF within 180 sec copyir.com after receiver detected FLAG signal copyir.com Remote unit is defective copyir.com SC PCB or MJR PCB are defective copyir.com
436 DCN received after transmitting FTT copyir.com Transmitter is defective or incompatible copyir.com Line quality is poor copyir.com
456 Received relay transfer request or confidential document to distribute to an end receiving station or all confidential mailboxes are used copyir.com
459 Failed training in Phase C copyir.com Line quality is poor copyir.com (Training signal is distorted due to line noise) SC PCB or MJR PCB are defective copyir.com
490 Sum of error lines exceeded the limit (Function Parameter No copyir.com 70) of 64 lines copyir.com Line quality is poor copyir.com SC PCB or MJR PCB are defective copyir.com
494 Interval between two EOLs was more than 10 sec copyir.com when receiver received message data copyir.com Transmitter is defective copyir.com Line quality is poor copyir.com (EOL is damaged due to line noise) SC PCB or MJR PCB are defective copyir.com
495 During reception, CD turned OFF or continued ON for long time copyir.com During communication, lost loop – current copyir.com Line is disconnected copyir.com Transmitter is defective copyir.com SC PCB or MJR PCB are defective copyir.com
496 CS of modem is not able to turn ON copyir.com SC PCB is defective copyir.com
501 Remote unit does not have compatible Modem copyir.com
502 During reception, CD turned OFF or continued ON for long time copyir.com During communication, lost loop – current copyir.com Line is disconnected copyir.com Transmitter is defective copyir.com SC PCB or MJR PCB are defective copyir.com
503 CS of modem is not able to turn ON during training copyir.com SC PCB is defective copyir.com Line is disconnected copyir.com
504 Polling is rejected from the remote station copyir.com No polling original is set copyir.com
505 Polling XMT is rejected copyir.com No polling original is set copyir.com
540 No response after transmitting 3rd CTC or DCN received copyir.com Incompatible interface copyir.com
541 No response after transmitting 3rd EOR or received DCN copyir.com Line is faulty copyir.com MJR PCB abnormal copyir.com
542 No response to the 3rd RR transmitted or received DCN copyir.com Remote unit is abnormal copyir.com
543 T5 timer (60 sec copyir.com) elapsed without MCF copyir.com Remote unit is abnormal copyir.com
544 Stopped Transmission after EOR Transmission copyir.com Line is faulty copyir.com MJR PCB abnormal copyir.com
550 Timer between frames in phase C has elapsed copyir.com Defective remote station copyir.com
554 Transmitted ERR after receiving EOR copyir.com Line is faulty copyir.com
555 Transmitted PIN after receiving EOR copyir.com Line is faulty and Operator Call requested by RX side copyir.com
570 Password or machine code did not match during remote diagnostic communication copyir.com
571 Remote unit did not have the remote diagnostic function copyir.com
580 Sub-address transmission to a unit that has their DIS bit 49 (NSF bit 155) OFF copyir.com Sub-address transmission to a unit that has no Sub-address function copyir.com
581 Sub-address Password transmission to a unit that has their DIS bit 50 (NSF bit 156) OFF copyir.com Sub-address transmission to a unit that has no Sub-address function copyir.com
601 ADF Door was opened during ADF transmission copyir.com
623 No original was in the ADF copyir.com (Builtin dialer engaged) Operator removed the original from the ADF after dialing was completed copyir.com Original was not set properly in the ADF copyir.com
630 Redial count over copyir.com No dial tone detected copyir.com Sensor dial tone is not detected copyir.com (destination dependent) Busy tone is detected copyir.com (destination dependent) T1 timer (35±5 sec copyir.com) elapsed without a signal from the receiver copyir.com
631 “STOP” button was pressed during Auto Dialing copyir.com
634 Redial count over with no response or busy tone was not detected copyir.com Note: U copyir.comS copyir.comA copyir.com and Canadian models will redial only once if a busy tone is not detected copyir.com Telephone line cable is disconnected copyir.com Wrong number is dialed copyir.com SC or MJR PCB is abnormal copyir.com
638 Power turned off with applicable data in memory or during communication copyir.com Power cord unplugged copyir.com Power failure occurred copyir.com
800 The machine was requested to relay a document but has no Relay Hub capability copyir.com
815 Mailbox is full copyir.com
816 “The received Polling Password did not match copyir.com The machine does not have Confidential Comm copyir.com capability copyir.com”
825 Parameter settings of the initial sending station are not properly set copyir.com
870 Memory overflow occurred while storing documents into memory copyir.com
880 File Access Error copyir.com
884 File Access Error copyir.com
فتوکپی رنگی زیراکس 7855
1404-03-07
