کونیکا مینولتا Konica-Minolta bizhub 131f

ایرادات دستگاهای کونیکا مینولتا  براساس کد می باشد شرکت کپی ایران در نظر داردتمامی سرویس منالها و رفع ایرادادت را در اختیار شما عزیزان قرار دهد

 

 

 

D   copyir.com0   copyir.com2    The remote unit is busy   copyir.com Try the call again   copyir.com
D   copyir.com0   copyir.com3, D   copyir.com0   copyir.com8    The remote unit didn’t respond, the call couldn’t be completed or stop was pressed uring dialing   copyir.com Retry the call   copyir.com If your machine repeats the message, call the remote fax unit’s operator and verify that unit is operating properly   copyir.com
D   copyir.com0   copyir.com6, D   copyir.com0   copyir.com7    Either the remote unit didn’t respond, the call somehow didn’t go through or STOP was pressed during dialing   copyir.com Try the call again   copyir.com
R   copyir.com1   copyir.com1    T1 time-out   copyir.com The calling unit was not a fax machine or the transmitting unit is having difficulties   copyir.com
R   copyir.com1   copyir.com2    The two fax machines were incompatible   copyir.com Your machine sends and receives only ITU-T
Group 3 fax communication, the industry standard since the early 1980s   copyir.com
R   copyir.com1   copyir.com4    Someone pressed <Stop> during fax reception   copyir.com
R   copyir.com2   copyir.com3    Poor phone line conditions made fax communication impossible   copyir.com Enable the one second pause after CED on Memory Switch 20   copyir.com Also try increasing the echo wait time on Memory Switch 21 if echo is on the line
R   copyir.com3   copyir.com1    No response to CFR   copyir.com DCN was received from the transmitter   copyir.com Poor line conditions made communication impossible   copyir.com Adjust the echo wait time on Memory Switch 21   copyir.com Try
increasing the output levels via Memory Switch 11   copyir.com
R   copyir.com3   copyir.com3    Too many errors were detected during data reception   copyir.com The carrier was interrupted   copyir.com Increase the data error rate on Memory Switch 20   copyir.com
R   copyir.com3   copyir.com4    DCN was received after FTT   copyir.com Communication was not possible at 2400 bps   copyir.com Poor phone line conditions prevented fax communication   copyir.com Enable the Eye Quality Check on memory Switch 31 and 32   copyir.com
R   copyir.com4   copyir.com1    The machine received too large length data that over your machine’s limit   copyir.com
R   copyir.com4   copyir.com2    MPS/EOM/EOP was not received   copyir.com Either the line disconnected before reception was completed or too many errors were detected by the receiving unit   copyir.com Adjust the data error rate on Memory Switch 20   copyir.com It may also be necessary to decrease the receive communication speed via Memory Switch 20   copyir.com
R   copyir.com4   copyir.com4    The receiving fax machine has reached its memory capacity   copyir.com
R   copyir.com5   copyir.com1    DCN was received instead of RR during ECM communication   copyir.com
R   copyir.com5   copyir.com2    Line noise or other problems prevented ECM reception   copyir.com
R   copyir.com8   copyir.com1    A compatibility error occurred   copyir.com
R   copyir.com8   copyir.com10    Line noise or other problems prevented line probing   copyir.com
R   copyir.com8   copyir.com11    The fax machine timed out while waiting for the retrain signal   copyir.com
T   copyir.com1   copyir.com1    T1 time-out   copyir.com The remote fax machine didn’t respond to your machine   copyir.com This usually occurs during a manual transmission or when an incorrect number was dialed   copyir.com Call someone at the remote machine   copyir.com

 

پست های مرتبط

دیدگاهتان را بنویسید

نشانی ایمیل شما منتشر نخواهد شد. بخش‌های موردنیاز علامت‌گذاری شده‌اند *

جستجو در مطالب

سوالی دارید؟

برای آگاهی از راه های ارتباط با ما، بر روی دکمه زیر کلیک کنید

مطالب جدید ...

در خبرنامه ما عضو شوید